new web:
http://bdml.stanford.edu/pmwiki
TWiki
>
Haptics Web
>
StanfordHaptics
>
HapticsForGaitRetraining
>
SystemImplementation
>
PagerMotors
>
PreparingMotors
(28 Aug 2010,
KarenNesbitt
)
Prepare Motors
Solder pager motor ends to two wired ribbon wire
Make sure small heat shrink wrap is on split ends of ribbon wire to be soldered
Heat shrink small wires so they just barely touch below motor
Make sure motor works before heat shrinking over solder
Heat shrink a larger tube over smaller wires so they stay together
(
shrink wrapped motor
)
Epoxy motor lightly so all crevices and wires are covered in thin layer
Test motor again to ensure it vibrates clearly through the epoxy
Crimp other end of wire and make sure connection is good as well
--
KarenNesbitt
- 27 Aug 2010
Copyright &© by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki?
Send feedback